![]() When you click "OK", the client should start transferring the firmware to the device and once done, the device will install the firmware and reboot. At "Remote Host" type in the default IP of the device i.e. ![]() At "Local File" click the button on the right, navigate to and select the downloaded firmware for the unit.To recover your firmware, perform the following steps: The device is now in recovery mode and able to accept new firmware packages. You will then see all the LED's on the device light up and flash 3 times before going into a sequence of 2 LED's flashing, then alternate 2 LED's flashing. Keep the reset button pressed for 20 seconds. Hold in the reset button on the device while powering the unit up.Start a continuous ping to the device's default IP (192.168.1.20) e.g.First, you'll need to put the device into Recovery Mode. ![]() You are now ready to start the process of recovering the Ubiquiti device. Put the Ubiquiti Device into Recovery Mode This will allow you to communicate with the device.Ģ. 192.168.1.xxx where “xxx” is any number between 1-254, excluding 20.
0 Comments
Leave a Reply. |